User Manual

97
99
100
99
98
97
27
96
97
98
97
96
27
77
83
120
Pre-Tap
These Holes
BB
BB
B
AA
AA
A
G E (ContinG E (Contin
G E (ContinG E (Contin
G E (Contin
ued)ued)
ued)ued)
ued)
23
Step E-16Step E-16
Step E-16Step E-16
Step E-16
 1. Place one of the Brake Caliper Plates (99) so the ears of the
Caliper rest against the Washers and inbetween the two Brake Sleeves
(97).
 2. Slide the Brake Rotor (100) onto the Brake Hub (98).
 3. Place the other Brake Caliper Plate inbetween the Brake Sleeves.
Step E-17Step E-17
Step E-17Step E-17
Step E-17
 1. Press the 2mm x 8mm Solid Pin (120) into the hole in the end of
the Brake Shaft (77) so that it extends evenly from both sides of the
Shaft.
 2. Slide the Brake Hub (98) over the Brake Shaft. Align the groove
in the Brake Hub with the Pin and slide the Hub over the Pin.
 3. Use the short, 4-40 Thread-Cutting Screw, included in the wrench
bag, to pre-tap the three holes shown in Figure E-16.
 4. Thread the two 4-40 x 5/8" Set Screws (27) all the way into each
of the two Brake Caliper mounting holes in the left Gearbox Half (83).
 5. Slip a 1/4" x .020 Washer (96) and a Brake Sleeve (97) over each
of the two 4-40 x 5/8" Set Screws.
Figure E-16
Figure E-17
27
96
Brake Hub Install:
Brake Caliper Install:
120
97