User Manual

103

101

102

Step E-18Step E-18

Step E-18

 1. Place a 1/4" x .020 Washer (96) over each of the two 4-40 x 5/8"

Set Screws (27) against the Brake Sleeve.

 2. Hold the Brake Lever Clips (101) in position on the Brake Lever

(102), slide the Brake Lever Clips over the 4-40 x 5/8" Set-Screws.

IMPORTANT NOTE:Be sure the top Brake Lever Clip points

towards the front of the Gearbox and the lower Brake Lever Clip points

towards the rear.

 3. Secure the Brake Lever Clips with two 4-40 steel Locknuts (95).

Tighten the Nuts until they are just snug, then back them off about

1/8 -1/4 turn, so the Brake Lever Clips are slightly loose.

 4. Insert a 3/16" E-clip (103) into the groove in the end of the

Brake Shaft (77) to retain the Brake Hub (98).

G E (ContinG E (Contin

G E (Contin

ued)ued)

ued)

Figure E-18

Brake Lever Assembly:

Gear Box Install:

 1. Place the Gearbox assembly onto the rear of the Chassis (19),

align the bottom for the Gearbox Halves (82)(83) with the rectangular

hole in the Chassis. The bottom of the Gearbox should be flush with

the bottom of the Chassis.

 2. Attach the Gearbox assembly to the rear of the Chassis with

four 4-40 x 3/8" Flat-Head Screws (20)

 3. Secure the Gearbox Brace (88) to the Chassis Brace (29) with

two 4-40 x 3/8" Cap-Head Screws (17).

Figure E-19

103

Step E-19Step E-19

Step E-19