User Manual

123

Step E-20Step E-20

Step E-20

 1. Insert two 4-40 x 7/8" Cap-Head Screws (33), one on each side

of the Rear Shock Tower (123), through the outer holes in the Rear

Shock Tower. The Screw should point towards the rear of the truck as

shown in Figure E-20.

 2. Secure the 4-40 x 7/8" Cap-Head Screws in the Rear Shock

Tower, by threading a 4-40 Nut (35) over each Screw and tightening.

Use the included Team Losi Wheel Nut Wrench to

secure the 4-40 nuts which can also be used to adjust the Slipper

Clutch, or remove the wheel Nuts.

 3. Thread a 3/8" Ball Stud (38) into the center hole on each side of

the Rear Shock Tower.

123

Figure E-20

Rear Shock Tower Assembly:

Step E-21Step E-21

Step E-21

 1. Place the rear Shock Tower (123) over the rear of the Gearbox

assembly (82)(83) so the holes in the Shock Tower line up with the

holes in top of the Gearbox.

*NOTE: The rear Shock Tower should fit tightly around the Gear-

box, double check to make sure the holes are lined up properly

before threading the screws in before proceeding.

 2. Place a gold Ball Stud Washer (9) over each of the 4-40 x 1/2"

Cap-Head Screws (31). Secure the rear Shock Tower to the Gearbox

by threading the 4-40 x 1/2" screws and Washers through the Shock

Tower and into the Gear Box.

Rear Shock Tower Install:

Figure E-21

G E (ContinG E (Contin

G E (Contin

ued)ued)

ued)