User Manual

130 131

114

G FG F

G F

Figure F-1

 1. Place a drop of Shock Fluid (132) on the grooved end of each

Shock Shaft [front (130), rear (131)]. Then slide a Shock Shaft through

the hex shaped end of the Shock Cartridge (114). Slide the Shock

Shaft through until it is approximately midway between the threads

and grooves, as shown in Figure F-1.

Step F-1Step F-1

Step F-1

Step F-2Step F-2

Step F-2

Shock Assembly:

Shock End Install:

IMPORTANT NOTE: Use caution when threading the Shock

Shaft Ends onto the Shafts. Avoid gouging or scratching the Shock

Shaft while gripping the Shock Shaft with pliers. By placing the edge

of a towel over the shaft, then gripping the portion of the Shaft cov-

ered by the towel. This method will work very well to protect the

Shock Shafts from damage.

 1. Using needle nose pliers, or small vise grips, grasp the front

Shock Shaft (130) between the grooves and thread a Shock End (133)

all the way onto the Shaft.

 2. Repeat Step 1 for the second front Shock Shaft and both rear

Shock Shafts (131).

 3. Carefully snap a 1/4" Shock Mount Ball (121) into each of the

Shock Ends.

Figure F-2

130

131

121

133

131

121

130