User Manual

SECTIONED VIEW OF

ASSEMBLED NUT WITH

O-RING PROPERLY

SEATED IN GROOVE.

139

126

G F (ContinG F (Contin

G F (Contin

ued)ued)

ued)

 1. Snap a Shock Spring Cup (140) onto each of the four Shock

Shafts (130) (131) and slide it down around the Shock End (133).

 2. Slide a red Shock Spring (141) over each of the shorter front

Shocks so that the Spring rests on the Spring Cup. Slide a pink rear

Spring (163) over the longer rear Shocks so that the Spring rests on

the Spring Cup.

 3. Thread a Shock Spring Adjustment Nut (139), with the hex end

pointing up, on to the top of all four Shock Bodies (137), (138). Tighten

the Shock Adjustment Nuts on to the Shocks until the nut just

touches the Spring.

*NOTE: Final adjustment will be made later in the ride height sec-

tion in the tips portion of the manual.

Figure F-6

Step F-5Step F-5

Step F-5

Step F-6Step F-6

Step F-6

Shock Adjustment Nut Assembly:

*Note: This step will only be used for mainte-

nance purposes. These come pre-assembled in the kit.

*NOTE: Place a drop of Shock Fluid onto each O-ring before

installing it into the Shock Adjusting Nut.This will allow the Nut

to thread onto the Shock Body easily.

 1. Place the O-ring (126) into the grove inside of the Shock Ad-

justing Nut (139), Be sure to seat the O-ring completely into the groove

as shown in Figure F-5B.

Figure F-5A Figure F-5B

Spring Install:

139

138

137

131

130

163

141

140

133