User Manual

164

119

EQUAL THROW IN

BOTH DIRECTIONS

 1. Install the carburetor to the engine as per the instructions

supplied with the engine. The carburetor throttle arm should be on

the left side of the engine as shown. Check that the arm has equal

throw from center, as shown in Figure H-7A. If the arm rotates more

in one direction, loosen the nut securing the arm and re-position the

arm.

*NOTE: If your engine comes equipped with a slide valve car-

buretor, the slide ball should be positioned to the left side of the

engine pointing up and forward.

 2. Tighten the carburetor locking screws or other mechanism per

the instructions included with your engine.

Figure H-7

Step H-7Step H-7

Step H-7

Figure H-7A

BaBa

g H g H

g H

(Contin(Contin

(Contin

ued)ued)

ued)

 1. Place a Ball Stud Washer (9) over the four 4-40 x 1/2" Cap-Head

Screws (31). Insert a 4-40 x 1/2" Cap-Head Screw through the four

holes in the engine as shown.

Use Thread-lock compound on the threads of the

Screws for the Engine Mounts to prevent the Screws from backing

out.

 2. Attach the engine to the Engine Mounts (164) by threading

the four Screws into the four holes shown.

*NOTE: The two Engine Mounts should be positioned with the

narrow end up as shown in Figure H-6.

IMPORTANT NOTE: Make sure that the Engine Mounts are

installed correctly as indicated in Figure H-6. The larger holes should

be positioned toward the front of the engine, and the four Screws

should be installed into the smaller holes.

*NOTE: Engines equipped with pull starts can be installed in

the XXX-NT AD2, in the same fashion as a non-pullstart engine.

Step H-6Step H-6

Step H-6

Figure H-6

Engine Mount Install:

Carburetor Install: