User Manual

165

167

166

170

171

169

BaBa

g Hg H

g H

(Contin (Contin

(Contin

ued)ued)

ued)

Figure H-8

 1. Press the paper Air Filter Element (165) into the large end of the

Air Filter Boot (166). Be sure that the side of the Paper Element with

the hole in it is inserted into the boot.

 2. Slide the foam Pre-Filter (167) over the Paper Filter.

Air filter oil should always be applied to the foam Pre-

Filter before running.Do not apply filter oil to the paper filter ele-

ment.

 3. Attach the Air Filter Boot to the carburetor. Secure the boot to

the carburetor with a 4" Tie-Strap (168). Tighten the Tie-Strap and cut

any excess material off of the Tie-Strap.

Step H-8Step H-8

Step H-8

Step H-9Step H-9

Step H-9

 1. Wet your finger with water and lightly moisten the exhaust

port gasket (170) and slide it in the Header flange on the Exhaust

Header (171).

 2. Place the Exhaust Header, with the Gasket installed, over the

exhaust port of the Engine and push the Exhaust Header onto the

engine. To aid in installation the Header can also be twisted while

being pushed on.

 3. Align the straight portion of the Header to be perpendicular to

the head of the Engine.

 4. Hook one end of the Header Spring (169) into the lower hole on

one side of the Header flange. Grasp the oppisite end of the Spring

with a pair of needle nose pliers and stretch the Spring around the

case of the engine and hook it into the lower hole on the opposite

side of the Header flange.

 5. Attach the second Spring by following the instructions in Step

4 to the upper holes in the Exhaust Header.

Figure H-9

Air Filter Install:

Exhaust Header Install: