User Manual

176

175

174

180

171

BaBa

g H g H

g H

(Contin(Contin

(Contin

ued)ued)

ued)

Figure H-15

 1. Cut an 10.5" (280mm) length of Fuel Tubing (176) from the

piece supplied.

 2. Cut one end of the 10.5" piece of Fuel Tubing at a 45

angle as

shown in Figure H-15A. Install the uncut side of the tubing to the

forward fitting on the top of the Fuel Tank (30).

 3. Wind the Fuel Tubing into a small loop and insert it into the

rectangular slot in the chassis brace (29) as shown and clip the Fuel

Line into the Fuel Line Clip (84) on the Chassis. Insert the cut end of

the tubing into the inside (small) hole in the tuned pipe. This fuel line

will serve as the fuel tank pressure line.

 4. Attach one end of the Fuel Tubing to the rear fitting on the top

of the Fuel Tank, and attach the other end to the fitting on the carbu-

retor. This will be your Fuel Line.

IMPORTANT NOTE: Make sure that the cut section of

Fuel Tubing is inserted all the way into the Tuned Pipe.

Figure H-15A

Step H-15Step H-15

Step H-15

Figure H-14

Step H-14Step H-14

Step H-14

 1. Secure the Tuned Pipe (175) to the Coupler (174) by wrapping

an 8" Tie Strap (180) around the Coupler, and the pipe, and tighten.

 2. Secure the Coupler to the Exhaust Header (171) by wrapping

another 8" Tie Strap around the Coupler and Header and tighten. Cut

off the extra length from both Tie Straps.

Pressure and Fuel Line Install:

Coupler Tie Strap Install: