User Manual

183

184

182

BaBa

g Ig I

g I

Figure I-1

Figure I-2

Step I-1Step I-1

Step I-1

Step I-2Step I-2

Step I-2

For best results clean the surfaces that the Two-Sided

Tape will be attached to with a mild rubbing alcohol. This will ensure

a good, strong bond. Allow the surface to fully dry before attaching

the Tape.

 1. Cut a piece of Two-Sided Tape (182) to the same size as the

bottom of the receiver (receiver not included). Remove the backing

from one side of the Tape and attach it to the bottom of the receiver.

 2. Remove the backing from the remaining side of the Two-Sided

Tape and attach the receiver to the side of the Chassis Brace (29),

between the two Receiver Box guide rails as shown. The receiver

should be mounted so that it is at least 1/8" above the Chassis (19)

and so that the Antenna is to the front of the truck.

 3. Plug the steering servo into the slot marked "Channel 1" on

the receiver.

 1. Route the antenna wire up, through the antenna mounting

post in the Chassis Brace (29).

 2. Slide the antenna wire through the Antenna Tube (183) (a

small drop of oil in the Tube will make this easier).

 3. While pulling the wire through the Antenna Tube, slide the

Antenna Tube down and push it firmly into the antenna mounting

post on the Chassis Brace.

 4. Fold the wire over the Antenna Tube and place the Antenna

Cap (184) over the Tube and extra wire.

*NOTE: If the antenna wire is shorter than the Tube, remove the

tube and cut enough off of the Tube so that the wire will extend

about 3/4" past the end of the Antenna Tube.

Receiver Install:

Antenna Tube Install: