User Manual

188

189

G I G I

G I

(Contin(Contin

(Contin

ued)ued)

ued)

Step I-5Step I-5

Step I-5

Figure I-5

 1. Attach the Grommets (supplied with your radio system) to the

throttle servo per the radio system instructions.

 2. Route the servo lead and plug through the slot in the bottom

of the front Servo Mount (188) and plug it into the slot marked

"Channel 2" in the receiver.

 3. Position the throttle servo and Switch Mount (189) over the

Throttle Servo Mounts so that the servo output shaft is to the front

of the truck, and the Switch Mount is to the right, as shown in Figure

I-5.

 4. Place a #4 Washer (23) over each of four 4-40 x 1/2" Cap-Head

Screws (31). Thread a Screw through each of the four Grommets in the

servo, through the slots in the Switch Mount, and into the four holes

in the top of the Servo Mounting Posts.

IMPORTANT NOTE: Do not overtighten the Screws! The pur -

pose of having the Grommets is to absorb the shock and vibration

from the gas engine. Overtightening the Screws will prohibit the Grom-

mets from working properly.

Throttle Servo Install: