User Manual

199

198

189

G I G I

G I

(Contin(Contin

(Contin

ued)ued)

ued)

Step I-7Step I-7

Step I-7

Step I-8Step I-8

Step I-8

 1. Remove the two small screws from the switch (supplied with

radio system). Place the switch, from the bottom, into the Switch

Mount (189), with the on position towards the front of the truck.

 2. Place the switch top plate (if applicable) over the switch, on

top of the switch mount. Line up the holes in the switch with the

holes in the top plate and secure the switch to the Switch Mount with

the two screws from the switch.

 3. Plug the switch lead into the slot marked "Battery" in the

receiver. Plug the opposite end into the batter lead.

 4. Plug the battery lead into the free end of the switch and make

sure that the switch is in the "off" position. Use a couple of small tie-

straps to secure the battery lead to the Gearbox Brace. This will keep

the wires away from any moving parts such as the Gears, Throttle and

Brake Linkages, etc.

Figure I-8

Figure I-7

 1. Slide the Receiver Cover (198) into place over the rails on the

Chassis Brace (29), so that the top lip of the Chassis Brace fits up

inside the Receiver Cover, and the notches at the bottom of the Re-

ceiver Cover fit into the holes in the Chassis (19). Be carefull to ar-

range the radio wires so that they fit through the mouse-holes in the

bottom of the Receiver Cover and are not pinched under the cover.

 2. Place the fuel line under the tab protruding from the side of the

Receiver Cover, this will keep the Pressure Line secured out of the

way. Ensure that the Pressure Line is not pinched.

 3. Slightly bend the Throttle Return Spring Eyelet (199). Place the

Throttle Return Spring Eyelet over one of the 4-40 x 3/8" Cap-Head

Screws (17), and thread the Screw through the forward hole in the

Receiver Cover and into the Chassis Brace.

 4. Thread the other 4-40 x 3/8" Cap-Head Screws (17) through

the rear hole in the Receiver Cover (198) and into the Chassis Brace.

Switch Install:

Receiver Cover Install: