User Manual

BB
BB
B
AA
AA
A
G I G I
G I G I
G I
(Contin(Contin
(Contin(Contin
(Contin
ued)ued)
ued)ued)
ued)
45
Step I-10Step I-10
Step I-10Step I-10
Step I-10
Figure I-10
Figure I-9
Step I-9Step I-9
Step I-9Step I-9
Step I-9
RR
RR
R
otarotar
otarotar
otar
y y
y y
y
VV
VV
V
alvalv
alvalv
alv
e Carbe Carb
e Carbe Carb
e Carb
urur
urur
ur
etoretor
etoretor
etor
ss
ss
s
If your engine comes equipped with a rotary valve carburetor, complete the steps in Figure I-9 through Figure I-15. If
your engine comes equipped with a slide valve carburetor, skip ahead to page 48 and complete the steps in Figure I-
16 through Figure I-22.
 1. Slide a Linkage Collar (192) over the end of the Throttle Z-bend
Wire(191) (the shorter of the two), and position it approximately 1/4"
(6mm) from the Z-bend. Secure the collar with a 4-40 x 1/8" Set Screw
(193).
 2. Place the Throttle Over-ride Spring (194) over the wire and
against the collar. Slide a plastic Over-ride Slider (195) onto the Wire,
so that the long end is towards the Z-bend.
 3. Place a Linkage Collar over the end of the Wire, so that the
Spring is not compressed, and secure it with a 4-40 x 1/8" Set Screw
(193). The Collar should be positioned close to the end of the Wire.
Final adjustments will be made later.
 1. Slide a Linkage Collar (192) over the end of the long, Brake Z-
bend Wire (197), and position it aproximately 2 1/4" (60mm) from the
Z-bend. Secure the Collar in place with a 4-40 x 1/8" Set Screw (193).
 2. Slide a plastic Over-ride Slider (195) onto the Wire (191), so
that the long end is towards the Z-bend. Place a 0.5" long piece of
Fuel Tubing (176) over the Wire and against the Slider.
 3. Slide a Linkage Collar over the end of the Wire until it just
touches the Fuel Tubing. Secure it with a 4-40 x 1/8" Set Screw. Once
again, final adjustments will be made later.
193
193
197
192
195
193
176
192
193
191
193
192
194
195
193
192
Brake Z-Bend Assembly:
Throttle Z-Bend Assembly: