User Manual

BB
BB
B
AA
AA
A
G I G I
G I G I
G I
(Contin(Contin
(Contin(Contin
(Contin
ued)ued)
ued)ued)
ued)
46
 1. Attach the throttle linkage to the Throttle Servo Horn by in-
serting a 2-56 x 1/2" Button-Head Screw (187) through the Over-ride
Slider (195) and into the inner hole in the Longer tab of the Throttle
Servo Horn (190). Once the Screw is snug up against the Over-ride
Slider, unscrew it one full turn to allow some movement between the
Arm and the Slider . Secure the screw with a 2-56 Lock Nut (201).
 2. Insert the Brake Linkage Z-bend (197) from the bottom, through
the middle hole in the shorter tab of the Throttle Servo Horn.
Figure I-13
Step I-11Step I-11
Step I-11Step I-11
Step I-11
Step I-13Step I-13
Step I-13Step I-13
Step I-13
Figure I-12
 1. Determine which Throttle Servo Spline Insert (200) will fit your
throttle servo by referring to the table on page 9, Figure C-3C.
 2. Press the correct Throttle Servo Spline Insert into the hexago-
nal hole in the bottom of the Throttle Servo Arm (190).
Figure I-11
 1. For rotary valve carburetors, you will need to remove the
straight, shorter arm of the Throttle Servo Arm (190), as shown in
Figure I-11. Cut off the Arm with heavy duty clippers or a Dremel
TM
hobby tool.
IMPORTANT NOTE: Follow all cutting tool manufactures warn-
ings and wear eye protection.
RR
RR
R
otarotar
otarotar
otar
y y
y y
y
VV
VV
V
alvalv
alvalv
alv
e Carbe Carb
e Carbe Carb
e Carb
urur
urur
ur
etoretor
etoretor
etor
ss
ss
s
Step I-12Step I-12
Step I-12Step I-12
Step I-12
187
201
190
200
190
197
201
187
195
190
Rotary Carb Servo Arm:
Servo Insert Install:
Linkage Assembly: