User Manual

202
190
199
192
193
102
195
191
190
BB
BB
B
AA
AA
A
G I G I
G I G I
G I
(Contin(Contin
(Contin(Contin
(Contin
ued)ued)
ued)ued)
ued)
47
Figure I-15
Step I-15Step I-15
Step I-15Step I-15
Step I-15
 1. Install the Throttle Linkage Z-bend wire (191) in the top hole of
the Throttle Servo Arm so that the wire is positioned on the side of
the Arm toward the engine.
 2. Ensure the serve is centered by turning the radio and receiver
to the on position, before proceeding.
 3. Press the Throttle Servo Arm (190) and Throttle Servo Spline
Insert (200) onto the output shaft of the servo, and secure it with the
screw included with your servo. Be sure the servo output shaft is
centered and the Servo horn is aligned properly, as shown.
 4. Insert the end of the Brake Lever (102) through the hole in the
Over-ride Slider (195) on the Brake Linkage.
 5. Place a Linkage Collar (192) over the end of the Brake Lever
and secure it with a 4-40 x 1/8" Set Screw (193).
*NOTE: The slider should fit loosely under the linkage collar
to prevent binding.
Figure I-14
Step I-14Step I-14
Step I-14Step I-14
Step I-14
RR
RR
R
otarotar
otarotar
otar
y y
y y
y
VV
VV
V
alvalv
alvalv
alv
e Carbe Carb
e Carbe Carb
e Carb
urur
urur
ur
etoretor
etoretor
etor
ss
ss
s
 1. Attach one end of the Throttle Return Spring (202) to the hole
in the Eyelet (199). Attach the other end of the spring to the hole
toward the edge of the Servo Arm (190) as shown.
 2. Remove the Air Filter (165) from the Air Filter Boot (166). Check
to see that the Throttle Return Spring is holding the carburetor closed,
and that the linkage is not pulling the carburetor open.
 3. Looking through the Air Filter Boot into the carburetor, check
the opening of the small, half-moon area near the side. This opening
should be approximately 1/32" (1mm) in the fully closed position. If it
is not, refer to your engine instructions and adjust the idle adjust-
ment screw until the opening is 1/32" (1mm) with the throttle closed.
NOTE:
Once you have completed the radio installation for a ro-
tary valve carburetor, skip ahead to page 51 and begin at
Figure I-23.
193
Throttle Return Spring Install:
Brake Collar Install: