User Manual

ManualsBrandsTeam Losi Racing ManualsHobbyXXX-NT Adam Drake 2 Kit

BaBa

g I g I

g I

(Contin(Contin

(Contin

ued)ued)

ued)

Step I-17Step I-17

Step I-17

Figure I-17

Figure I-16

Step I-16Step I-16

Step I-16

Slide Slide

Slide

alvalv

alv

e Carbe Carb

e Carb

urur

etoretor

etor

 1. Thread the 4mm Ball Cup (204) all the way onto the end of the

Threaded Throttle Rod (203). Slide a Linkage Collar (192) over the

other end of the Throttle Rod, and up against the Ball Cup. Secure the

collar with a 4-40 x 1/8" Set Screw (193).

 2. Place the Throttle Over-ride Spring over the rod and against

the Collar. Slide a plastic Over-ride Slider (195) onto the rod, so that

the long end is away from the Ball Cup.

 3. Place a Linkage Collar over the end of the rod, so the springs

are not compressed, and secure it with a 4-40 x 1/8" Set Screw. The

collar should be positioned at the end of the rod. Final adjustments

will be made later.

 1. Slide a Linkage Collar (192) over the end of the long, Brake Z-

bend Wire (197), and position it approximately 1/4" (60mm) from the

Z-bend. Secure the Linkage Collar in place with a 4-40 x 1/8" Set

Screw (193).

 2. Slide a plastic Over-Ride Slider (195) onto the wire, so that the

long end is towards the Z-bend. Place a 0.5" piece of Fuel Tubing

(176) over the wire and against the slider.

 3. Slide a Linkage Collar over the end of the wire until it just

touches the Fuel Tubing. Secure it with a 4-40 x 1/8" Set Screw. Once

again, final adjustments will be made later.

193

NOTE: If your engine comes equipped with a slide valve carburetor, complete

the steps in Figure I-16 through Figure I-22.

192

176

192

193

195

193

197

193

192

194

195

192

193

204

203

Throttle Linkage Assembly:

Brake Z-Bend Assembly: