User Manual

ManualsBrandsTeam Losi Racing ManualsHobbyXXX-NT Adam Drake 2 Kit

BaBa

g I g I

g I

(Contin(Contin

(Contin

ued)ued)

ued)

 1. Attach the throttle linkage to the Throttle Servo Arm by insert-

ing a 2-56 x 1/2" Button-Head Screw (187) through the Over-ride Slider

(195) and into the middle hole in the longer arm of the Throttle Servo

Horn (190) from the bottom. Once the Screw is snug up against the

Over-ride Slider, unscrew it one full turn to allow some movement

between the Arm and the Slider. Secure the screw with a 2-56 Lock

Nut (201).

 2. Insert the Brake Linkage Z-bend (197) from the top, through

the middle hole in the shorter arm of the Throttle Servo Horn (190).

Figure I-20

Step I-18Step I-18

Step I-18

Step I-20Step I-20

Step I-20

Figure I-19

 1. Determine which Throttle Servo Spline Insert (200) will fit your

throttle servo by referring to the table on page 9, Figure 9C.

 2. Press the correct throttle servo spline insert into the hexagonal

hole in the bottom of the Throttle Servo Arm (190).

Figure I-18

 1. For slide valve carburetors, you will need to remove the shorter,

perpendicular Arm of the Throttle Servo Arm (190), as shown in Fig-

ure I-18. Cut off the Arm with heavy duty clippers or a Dremel

hobby tool.

IMPORTANT NOTE: Follow all cutting tool manufactures warn-

ings and wear eye protection.

Slide Slide

Slide

alvalv

alv

e Carbe Carb

e Carb

urur

etoretor

etor

Step I-19Step I-19

Step I-19

187

201

190

200

197

201

190

195

187

Slide Carb Servo Arm:

Servo Insert Install:

Linkage Assembly: