User Manual

119

G B (ContinG B (Contin

G B (Contin

ued)ued)

ued)

Step B-4

Step B-5

Figure B-5

IMPORTANT NOTE: Do not overtighten the Ball Studs in the

Spindle Carriers.

 1. Insert a 3/8" Short Head (Silver Colored) Ball Stud (72) into

the middle of the top holes in the left Spindle Carrier (43), from the

front as shown, and tighten.

 2. Insert a 4-40 Mini Locknut (7) onto the hex area in the top of

the left Spindle (42). Place a #4 Washer (23) over a 3/8" Ball Stud

(38) and thread it into the Mini Nut from the bottom of the Spindle,

and tighten.

 3. Repeat Steps 1-2 for the right side Spindle Carrier Asembly.

Once assembly of your new XXX-NT AD2 is com-

plete, you may notice that the tires toe-in slightly as the suspension

compresses. We have found this setting to yield the best performance.

Should you prefer to change this so that the tires do not toe in, you

can remove the Ball Stud Washer under the Ball Stud on the Spindles.

Figure B-4

Spindle Carrier Assembly:

Ball Stud Install:

 1. Insert a front Axle (39) into each of the front Spindles [left

(42), right (40)] as shown. The hole in the Axle should line up with

the hole in the Spindle.

 2. Attach the left Spindle (42) to the left Spindle Carrier (43) by

aligning the holes in each part and inserting a 1/8" x 1.250" Hinge

Pin (44) from the bottom. Do not insert the Pin all the way through

both parts yet.

 3. Insert a plastic .050" front Spindle Spacer (45) between the

top of the Spindle and the Spindle Carrier as shown in Figure B-4.

Once the Spacer is in place, insert the Hinge Pin through the Spacer

and the top of the Spindle Carrier.

 4. Center the Hinge Pin and secure it with two 1/8" E-clips (46).

Apply a small drop of Thread Lock (119) (found in this bag) to a 5-

40 Set Screw (47). With the Hinge Pin still centered, thread the Set

Screw into the back side of the Axle and tighten.

 5. Repeat Steps 1-4 for the right Spindle (40) and right Spindle

Carrier (41).