Power Inverter Owner's Manual

PMP1200 Models
Owner’s Manual
Reason Solution
Poor contact with Clean terminals
battery terminals. thoroughly. Reattach
battery clips.
Using incorrect type of Use true RMS reading meter.
voltmeter to test
output voltage.
Reason Solution
Battery voltage below Recharge or replace battery.
10.0 ± 0.5 volts.
Equipment being operated Use a higher capacity inverter
draws too much power. or do not use this equipment.
Inverter is too hot (thermal Allow inverter to cool.
shutdown mode). Check for adequate ventilation.
Reduce the load on the
inverter to rated continuous
power output
Unit may be defective. See Warranty and call
Customer service at
1-888-231-4022.
Troubleshooting
PROBLEM: Low or No Output Voltage
PROBLEM: Red LED On
7
Reason Solution
Electrical interference from Add an AC interference filter on
the inverter. to the TV power cord. Refer
to TV and audio section of
this manual.
Reason Solution
TV does not turn on. Try turning the inverter
ON/OFF/ON.
Contact TV manufacturer for
start up surge and power
consumption.
A larger inverter may
be required.
PROBLEM: TV Does Not Work
Reason Solution
Input voltage below 10.5 ± 0.5 volts. Keep input voltage above 10.5±0.5
volts to maintain regulation.
Poor or weak Recharge or
battery condition. replace battery.
Inadequate power being Make sure connection is secure.
delivered to the inverter Use lower gauge wire. Keep
or excessive voltage drop. wire length as short as possible.
Troubleshooting
PROBLEM: TV Interference
PROBLEM: Low Battery Alarm On All The Time
8