User manual

Contents:
1 x mounting frame (1)
1 x front (2)
1 x metal angle with mounted speaker (3 W / 8 Ohm)
and cable with 3.5mm plug (3)
2 x screws for the front cover (4)
Preparation:
1. Check the contents.
2. Locate the antenna and power cables for mounting in the radio compartment.
Note: The power supply cable of the radio can be shortened if needed. Nevertheless, never remove the fuse holder
with the fuse.
Mounting:
1. Remove the front cover from the mounting frame by loosening the screws.
2. Place the mounting frame in the radio compartment at the proper location.
Place the antenna and power cable in its final position. Secure the frame in
the radio compartment by pushing the claws outside.
3. Mounting of the front cover to the radio
a) Move the front cover over the front of the radio to the end and attach the radio on
the outside bracket with one knurled head screw (5). Pay attention to the proper
placement of the front cover (see photo).
b) Place the metal angle with the mounted speaker over the inner bracket hole and
attach it with the second knurled head screw (5).
4. Plug in the 3.5 mm connector into the external speaker jack, located at the rear of the
radio.
5. Connect the PL antenna plug with the antenna jack, located on the rear of the radio.
6. Connect the power supply cable (red: plus / black: minus).
7. Test the radio before connecting the front cover to the frame.
TEAM Electronic GmbH
Bolongarostraße 88 ++49 69 3009500
65929 Frankfurt am Main www.team-electronic.de
Mounting Instructions EBS-TS-6M FSP
DIN Radio Compartment Mounting Kit including Screws with Front Speaker for TEAM TS-6M
(1) + (2)
(3)
(5)
For mounting of the radio onto the mounting
frame, use the knurled head screw (5) that is
included in the contents of the TS-6M radio.