Operation Manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
        
language integrity.
13 TEAM SIS 12 - 100222
Assembly page 13/60
Fax [phone]
STEAM-IRONING
 Fill the water tank with water and insert the mains plug into a wall socket.
 As indicated on the temperature dial (5) and in the table, steam ironing is only possible at
higher ironing temperatures, so set the dial to  or .
 Put the switch (1) in ON position ("1") and set the temperature dial of the iron (5) to the
desired position. When the iron has reached the desired temperature, its pilot light (8) will
go out. You can now use the steam function.
 Turn the steam control knob (12) to regulate the amount of steam. Note: the maximal
steam rate can only be used when the ironing temperature is higher than position
, or else water will drip from the sole.
 Press the steam button (6) to release steam from the soleplate of the iron. Release the
button and the steam will stop. If you want a continuous jet of steam, press the steam
button down and slide its transparent top part backwards so that the steam button locks.
To stop the continuous jet of steam, push the transparent part of the button forwards
again and release the steam button.
 When ironing, the pilot light of the iron (8) will go on and off from time to time. This means
that the temperature of the iron is regulated by its thermostat. You can continue ironing.
The pump pilot light will also go on and off, indicating that the steam pressure is being
regulated.
 When you use a lot of steam in a very short time, the steam output is lightly reduced until
your appliance produces enough steam to reduce the difference. This phenomenon also

 When the water tank is running empty, you will hear more noise when pressing the steam
button. If you want to go on using the steam function, you will have to refill the water tank.
STEAMING IN A VERTICAL POSITION
Position the temperature dial on its maximum level for vertical steam ironing. The steam rate
can be adjusted according to your needs.
You have to hang the cloth you want to smooth out avoiding the creases and place the iron in
a vertical position at a few centimetres from the piece of cloth. Then move the iron and press
the burst of steam button at the same time.
DRY IRONING
 Plug in the appliance and switch it on (power 
 Use the temperature dial to set the temperature needed.
 When the indicator lamp of the iron goes out for the second time, you can start ironing.
 For ironing without steam, leave the steam control knob in OFF position and do not press
the steam button (6).
WHEN FINISHED IRONING
 We recommend cleaning the iron after use as follows: fill the water tank, put the

heat for 10 minutes. When the temperature has been reached, take the iron from the
base, hold it vertically and keep the steam button pressed for 30 seconds, then wait 30
seconds and repeat this cycle twice.
 , unplug the appliance and let it
cool down.
 Empty the water tank.
 We recommend placing the iron on its base when you store it. The therefore foreseen
place is non-slip and will not damage the soleplate of the iron.