Instructions / Assembly

ManualsBrandsTeamson Home ManualsFire Pits20 in. Outdoor Square Slate Rock Gas Fire Pit

Summary of content (11 pages)

PAGE 1
PAGE 2
- *(6 4 ( )( % % % % * !% %( + " % !' " % !+( , "' % " %(( * ' " &% ( " "(("- * % , -% % % " " % * "- !% %( !%. ( % " /'(" " % %!% " ' "' ., " +" (. 0 .
PAGE 3
" " * +"-( " ; * ( " +"% (-%. "' % * %''( % " (% " " "" !"; * )? "; "! * +"-( + " "' % * %''( % " " (%. * )? "; "; * +"-( ( " % "!'( (. ""( "- % ' " " " % % 3" " , * ' "'% +"-( *" ( + * < " % ( %< % + "+ " + " 1* ' "'% +"-( *" ( ; + +. * ( * ( ! + ' ; -* * . % % .
PAGE 4
PAGE 5
PAGE 6
PAGE 7
- + 1* ! + ( % % " "+ " % %(( ! " ' "' "' % " 1* + " * +"-( ! + "; +. (%;% " < "!'( (. # * - * (%! !%. + / * * & " * # 7 1 % # 7 1 -%. " = *=( = *=( ) " ! ( %< % - (( ; (% % % " % -* " " " '% < % " !"; +% . "! #' % < ;%(; ((.
PAGE 8
( *A( -5 ) * * " "( < "+ % (" <- " * R#&&C '" " 1 * .( ;%(; " * % % < (" <- " (" * % ''(. " " % (" ! + ("- ( * = * D ' ." +"-( % ( % "! "!+ +( !% %( ? %((. ' + "! "+ " % < ' '(% % ( % "! + * + % (%;% " < % "!'( (.
PAGE 9
Helpful Tips If the burner will not light or stay lit, please perform the following checks. It is possible that the Excess Flow Safety Device has been tripped. Turn the control knob to oﬀ and close the LP Gas tank valve. Disconnect the regulator. Turn the Control Knob to “HIGH”. Wait a minimum of 5 minutes. Turn burner control knob back to “OFF”. Reconnect the regulator and perform a leak check at tank connection. Turn the LP Gas tank valve on slowly, wait 30 seconds and then light the outdoor ﬁre table.
PAGE 10
Troubleshooting Problem: Burner will not light using igniter Please review the Helpful Tips for common ﬁxes to this problem. Possible Cause 1: Electrode and burners are wet. -Wipe dry with cloth. Possible Cause 2: Igniter battery is dead or backwards. -Check that the AAA battery is inserted correctly in the igniter (see page 10) or replace the battery. Make sure the plastic wrap on the battery has been removed. Possible Cause 3: Igniter Pin cracked or broken - sparks at crack.
PAGE 11
Troubleshooting Problem: Sudden drop in gas flow, or a reduced flame height Possible Cause 1: Out of Gas. -Check for gas in the LP gas tank. Possible Cause 2: Excess flow safety device may have been activated. -Turn control knob to “OFF”, wait 30 seconds and light outdoor ﬁre table. If ﬂames are still too low, reset the excessive ﬂow safety device by turning oﬀ the control knob and LP gas tank valve. Disconnect regulator. Turn burner control knob to “HIGH”. Wait at least 5 minutes.