Operating Manual

12
6.5 Connecting/ switching on NelumBox®
Make sure that only items or goods that may be cooled or heated to
the selected temperature are stored in the device.
After powering up, the battery status and interior temperature of
NelumBox® immediately show up on the display. Before each trans-
port, make sure that all general conditions for the transport are safely
observed!
The batteries can be charged by the Docking-Station. For more infor-
mation about that device read the RRC2054-2 manual or contact RRC
power solutions GmbH.
Warning!
• Place the unit on a firm base.
• Close the door.
• If the batteries are discharged or the batteries are not used,
connect the unit to an AC power socket using the supplied
AC power connection cable. Close the door.
• Press the power switch on the back of NelumBox® to turn on
the device. NelumBox® welcomes a successful start-up with
the NelumBox® logo.
• The cooling unit now starts to heat or cool the interior to the
previously set temperature.
• Yellow: When attempting to open the door via button, but
RFID is required. / Battery lower than 10%. / If the temperature
deviates by up to +/-0.5°C, after reaching the target
temperature range. / Door is opened longer than 22 seconds.
AC power socket
power switch