Owner's manual

2322
It doesn’t boot.
The battery is too low. Charge your TECBOT M1 using the
charging dock and try to boot again. Ensure environment
temperature is not too low (below 32 ºF ) or too high
(above 122 ºF). Recommended environment temperature
is between 32-104 ºF.
It doesn’t charge
Ensure that both ends of the charging dock power
cord are plugged in. Clean the charging station and
TECBOTM1contactpoints.Conrmthechargingdock
indicator is on.
It doesn’t return to the charging dock station.
Put the charging dock in an open area. Place your
TECBOT M1 near the charging dock and try again.
Conrmwhethertherechargerispowered.Cleanup
the signal emitter area and charging contact points
regularly.
Does charging on the charging dock all the time
consumes power?
No, when your TECBOT M1 charge on the charging dock
it consumes low electrodes, which helps to keep the
battery performance at its best.
Do I need to charge my TECBOT-M1 for sixteen hours
before the rst three uses?
No, there is no need to charge lithium-ion batteries fully.
Theyhavenomemoryeectwhenused.
It doesn’t return to recharge after partial cleaning or
moving away.
Your TECBOT M1 will redraw the map after a partial
cleaning or long-distance movement. It may not be able
to return to recharge if the charging base is too far away.
Manually put your TECBOT M1 into the charging dock.
After selecting the Automatic mode, my TECBOT M1
switches to Sweep mode.
Wipe clean with a paper towel the surface of the
wastewater tank and its left and right installation places.
Restart the Automatic Mode
Cleaning ability decreased, or dust is dropping.
Thedustboxbinhaslledup,theltersareblocked,and
entanglement on the V-shape main brush, edge-cleaning
brushes, needs to be clean. Turn OFF your TECBOT M1
before cleaning.
Mopping ability decreased.
Cleananydirtontheltersofthewastewatertankand
cleanit.Checkwhetherthecleanwatertankislled.Fill
up the clean water tank before start cleaning.
Troubleshooting and FAQs
It felt out steps during cleaning.
Checkandwipecleanalltheclisensors.
Abnormal noise during cleaning
Turn OFF your TECBOT M1 for cleaning.
Clean any entanglement on the V-shape main brush,
edge-cleaning brushes, or wheels.
Abnormal behavior
Restart your TECBOT M1 by turning it OFF and ON.
It doesn’t avoid obstacles
Check and clean the front and side sensors.
Tecbot Home App can not be paired.
• Check your home Wi-Fi router supports the 2.4GHz
frequency band.
• Check your home Wi-Fi password input is correct.
• CheckyourWi-Firouterdoesnothasarewall.
• Check if the Wi-Fi indicator of your TECBOT-M1 is still
blinking.
The scheduled cleaning does not happen.
When the battery is low, the scheduled cleaning will start
after the battery level is above 20%.
Add family members to the Tecbot Home App.
Tap “My” to select family management
Tecbot Home App does not have a map.
Tap “Smart plan cleaning.” Tap “more” to save the map in
the map management after the TECBOT M1 icon appears.
“Selection cleaning” can not be selected
You can edit the map after the map is saved.
Create smart cleaning
Open the Tecbot Home App and tap “Smart.”
Tab the “plus symbol” to add.
Change cleaning mode
Tap “More” to select a cleaning mode