Owner's manual

98
Before operating your TECBOT M1, please remove
any tripping hazard, litter, quickly falling objects and
valuables, and potentially dangerous items from the
oortoavoidpersonalorpropertydamages.
Please, prevent your TECBOT M1 from coming in close
contactwithopenamesorhigh-temperatureequipment
duringoperationtoextenditslifetimeandavoidres.
Precaution
Please, retrieve the clean water
and wastewater tanks when
turning over your TECBOT M1.
!
NOTE:
The ON/OFF switch is at the bottom right side of your TECBOT M1. (“1” position for ON and “0” for OFF).
Your TECBOT M1 will self-check for about 10 seconds before turn ON.
Installation
01 After taking your TECBOT M1 out of the box, remove
the protective foam on both sides.
02 Check whether all components are in place:
wastewater tank, V-shape main brush, edge-cleaning
brushes, and dust box.
03 Placethechargingdockagainstawallonaleveloor,
and connect it to a power source. Make sure there are
more than 5.3 feet of free space in the front and 2
feet to the sides of the charging dock.
04 Place your TECBOT M1 at the charging dock.
05 Turn ON your TECBOT M1.
06 Removethecleanwatertankbyitsnger-pulls.Fill
it, close it and place it back into your TECBOT M1 and
close the top lid.
07 Your TECBOT M1 is ready for Wi-Fi pairing.
2 ft
5.3 ft
2 ft
ON/OFF switch