Operation Manual

9
GETTING STARTED
SETTING UP
Follow the steps below to install the Desk phone.
- Connect the receiver to the device with the curly cord.
- Remove the battery cover with the Allen key then remove the battery and insert an appropriate SIM card into the device.
- Insert the battery into the battery compartment, ensuring the polarity on the battery matches the polarity of the connectors and the
cover is positioned correctly and secured into place.
- Connect one end of the power adaptor to the Power adaptor/ charger port. Plug the power adaptor into a mains power outlet. The
battery level indicator will stop moving when the device is fully charged.
- When the phone is powered up for the rst time, the default language will be in English. Please refer to the “LANGUAGE” section of
the manual to select an alternative language.
CHARGING THE UNIT
When the battery level is low, there will be a warning tone, a low battery message will be displayed and the empty battery icon will
ash. Plug the power adaptor into the unit to start charging. The battery level indicator will ash during charging mode and once it has
charged, the full battery icon will appear. Charging a completely at battery may take 2 to 3 hours.
POWERING ON/OFF
Press the [ ] button for 2 seconds and the phone will turn ON. The backlight will illuminate and automatically search for a network
operator. When the operators name is shown on the screen, press the [ OK ] button again for 2 seconds. When prompted to INSERT
CODE input the PIN code “2580” and press the [ OK ] button to conrm. The phone is now in Standby mode and is ready to be used. To
turn OFF the device, press the [
] button for 2 seconds.
Note:
If the power source and battery is connected to the device and there is no SIM card inserted in the device the LCD will display “no SIM
card”. If the SIM card is damaged or your network is not authorised to be used on the device the LCD will display “PLEASE INSERT USIM
Card”. For further information please contact your network operator. Always ensure the device is switched OFF before removing the SIM
card. This will prevent damage to the SIM card and data loss. Do not place the SIM card near any electromagnetic surfaces or
environments and avoid touching the metal connectors on the SIM card. For further information please contact your network operator.