Installation & Assembly

Installation Instructions for

Vessa Ceiling (LED)

1.0

980VESSAC

Ceiling

FM842_LED

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing NEC compliant

junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

Remove the mounting plate from the fixture base by

unscrewing the two knurled nuts from the two

threaded studs.

KNURLED NUT

THREADED

STUD

MOUNTING

PLATE

FIXTURE BASE

Install the Mounting Plate

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

MOUNTING

PLATE

Mount the mounting plate to the electrical box with

the two #8-32 screws.

#8-32 SCREW

ELECTRICAL BOX

PAGE 1
Installation Instructions for 980VESSAC Vessa Ceiling (LED) FM842_LED 1.0 Ceiling GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product may be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation.
PAGE 2
Install the Fixture Install the Shade 2A 3A FIXTURE BASE 1 2 PHILLIPS SCREW 3 FIXTURE SHADE 1 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 2 Connect the white driver wire to the neutral power line wire with a wire nut. 3 Connect the black driver wire to the hot power line wire with a wire nut.