Buying Guides

21
WALL MONORAIL SYSTEM
Step One: Choose your decorative elements
Choose finish of system and make sure all components are specified
as such.
Choose elements (Heads) from decorative elements (pp. 9-10).
Add up total lamp wattage on system to confirm wattage does not
exceed transformer capacity.
Step Two: Choose your rail
Measure length of Wall Monorail run; determine quantity and length
of Wall Monorail sections required (p. 65).
Step Three: Choose your connectors
Use a Straight Conductive Connector for joining multiple pieces of
rail. Pair. (p. 65)
Straight Isolating Connectors join sections of Wall Monorail and
must be used when isolating one powered section from another.
Typically they are used to separate 2x300 watt sections when using
a 12 volt, 600 watt surface transformer. They must also be used
when multiple surface transformers or canopies are used on a
continuous run. Pair. (p. 65)
Use an Adjustable Angle Conductive Connector if the run includes a
sharp angle or turn. Pair. (p. 65)
Add End Caps to finish off the ends of the run. 4 pc. set. (p. 65)
(BZ) Bronze or (SC) Satin Nickel
Page numbers below reference the Full Line Catalog
Determine item numbers. If using with a 24 volt transformer, specify
at the end of each element item number (pp. 138-169).
Specify one Wall Monorail Rail Adapter for each element (not
required for Display Lights).