Installation Sheet

2
COM X1 X2 X3 X4
Install the Remote Transformer
NOTE: In order to use small gage wires from the
transformer to the electrical box, it is recommended to
install the remote transformer near (if possible) the
electrical box. See "Low Voltage Wire Size Table"
below.
Use the transformer brackets to mount the transformer
and secure it in place (hardware not included).
Remove the transformer cover by loosening the two
Phillips screws on the side of the transformer.
TRANSFORMER
BRACKET
TRANSFORMER
BRACKET
PHILLIPS
SCREW
1
2
1
1
2
2
COM X1 X2 X3 X4
Install a conduit and power line wires from the panel to
remote transformer.
connect the power line wires to the panel at this
time.
Connect the 120V black transformer wire to the hot
power line wire with a wire nut.
Connect the 120V white transformer wire to the neutral
power line wire with a wire nut.
Do not
HOT POWER
LINE WIRE
NEUTRAL
POWER
LINE WIRE
3
4
5
6
3
CONDUIT
5
6
TRANSFORMER
WATTAGE
WIRE SIZE
FOR5FT
WIRE SIZE
FOR 6-15 FT
WIRE SIZE
FOR 16-20 FT
WIRE SIZE
FOR 21-40 FT
WIRE SIZE
FOR 40-60 FT
WIRE SIZE
FOR 61-90 FT
LOW VOLTAGE WIRE SIZE TABLE
75 WATT #8 GA #6 GA #4 GA #2 GA #1 GA#12 GA
1A
TRANSFORMER COVER
1B
4