Manualshelf

Installation Sheet

ManualsBrandsTech Lighting ManualsRail & Cable LightingTech Lighting 300W Single Circuit Electronic DC Remote Transformer for Low Voltage Systems
1234
4
TRANSFORMER
COVER
PHILLIPS SCREW
Connect the 120 volt power line wires at the panel.
After installing the entire system, operate the system for
five minutes. On the low voltage side, all electrical
connection points should be no more than warm to the
touch. If a connection is hot to the touch, retighten the
connection and check to ensure that the temperature
decreases.
Replace the transformer cover and tighten the four
Phillips screws.
1A1D
12
14 14
14 14
12
13
14