Installation Sheet

1.0
Installation Instructions for
Dobson II 1 Light Bath
700BCDBS1
1
920BCDOBSII1
2
1
With the provided Allen wrench, loosen the set screw on the bottom of the fixture base.(do not remove)
Remove the mounting plate from the fixture base
Install the mounting plate to the junction box with the two #8-32 screws provided.
Verify that the mounting plate is level before continuing. Line up an anchor tip with the center of an anchor hole, and push the anchor
into the wall up to the threads.
Screw the anchor in the rest of the way with a Phillips-head screwdriver. Repeat for the other anchor hole.
Slide an anchor screw through a washer, and screw it into an anchor to secure the fixture base to the wall.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line.
Connect the black driver wire to the hot power line.
Properly place the driver, all wires, and wire nut connections into the electrical box, and attach the mounting plate to the junction box
using the two provided #8-32 screws.
Mount the fixture back onto the mounting plate and reinstall the set screw (reversal of step 1A).
CAUTION RISK OF FIRE-
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and
operation of the product and the hazards involved.
Use minimum 90°c supply conductors.
1A
Install the Fixture
4
3
6
5
7
ALLEN WRENCH & SET SCREW
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed
utilizing NEC compliant junction boxes.
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic
dimmer.
This instruction shows a typical installation.
BCATH OLLECTION
8
9
MOUNTING PLATE
DRIVER
7
9
8
11
10
ANCHOR
ANCHOR SCREW
& WASHER