Installation Sheet

1.0

Installation Instructions for

Jaxon Bath (LED)

700BCJXN24_-LED

920BCJAXOND

GP I :ENERAL RODUCT NFORMATION

This product can mount to either a 4" square electrical box

with round plaster ring or an octagon electrical box.

This product is dimmable with a low-voltage electronic

dimmer.

This product is suitable for damp locations.

BCATH OLLECTION

Install the Backplate

Remove the two #8-32 screws on the backplate with a

Phillips head screwdriver.

Remove the backplate from the sconce base.

#8-32 SCREW

SCONCE BASE

BACKPLATE

CAUTION - RISK OF FIRE

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

BACKPLATE

LONG #8-32 SCREW

ELECTRICAL BOX

Temporarily mount the backplate to the electrical box

with two long #8-32 screws.

3 3

PAGE 1
920BCJAXOND Installation Instructions for Jaxon Bath (LED) 700BCJXN24_-LED 1.0 B ATH C OLLECTION GENERAL PRODUCT INFORMATION: This product can mount to either a 4" square electrical box with round plaster ring or an octagon electrical box. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
Connect the Power 1C 2A BACKPLATE MARKED POINT 2 5 5 5 5 5 4 Verify that the backplate is leveled before continuing. 5 Mark the four anchor locations. 1D 3 ANCHOR 7 7 4 1 Connect the backplate to a suitable ground according to local electrical codes. 2 Connect the black driver wire to the hot power line wire with a wire nut. 3 Connect the white driver wire to the neutral power line wire with a wire nut. 4 Properly place all wires into the backplate.