Installation Sheet

Installation Instructions for

Lufe Round and Square Bath

920BCLUFE

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product can mount either to a 4” square electrical box with a

round plaster ring or an octagon electrical box.

May be dimmed with a low-voltage electronic dimmer.

This instruction shows a typical installation.

Remove the fixture screws located on the top and

bottom of the fixture base.

Remove the mounting plate from the fixture base.

FIXTURE

SCREW

Install the Mounting Plate

Attach the mounting plate to the electrical box using

the two #8-32 screws provided.

#8-32 SCREW

MOUNTING

PLATE

1.0

700BCLUFE_

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

BCATH OLLECTION

PAGE 1
Installation Instructions for 920BCLUFE Lufe Round and Square Bath 700BCLUFE_ B ATH C OLLECTION GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product can mount either to a 4” square electrical box with a round plaster ring or an octagon electrical box. May be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation.
PAGE 2
Install the Fixture 2A FIXTURE BASE 3 1 SAVE THESE INSTRUCTIONS! 2 1 Connect the mounting plate ground wire to a suitable ground according to local electrical codes. 2 Connect the black driver wire to the hot power line wire with a wire nut. 3 Connect the white driver wire to the neutral power line wire with a wire nut. 4 Properly place the driver, all wires, and wire nut connections into the fixture base.