Installation Sheet

1.0
Installation Instructions for
Oko 1 Light Bath
700BCOKO1
1
920BCOKO1
2
1
With the provided Allen wrench, loosen the set screws on top of the fixture base.(do not remove)
Remove the mounting plate from the back of the fixture.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line.
Connect the black driver wire to the hot power line.
Properly place the driver, all wires, and wire nut connections into the electrical box, and attach the mounting plate to the electrical box
using the two provided #8-32 screws.
Mount the fixture back onto the mounting plate and reinstall set screws (reversal of step 1A).
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1A
Install the Fixture
4
3
6
5
7
MOUNTING
PLATE
ALLEN
WRENCH
ALLEN
SCREW
GENERAL PRODUCT INFORMATION:
These fixtures are intended to be installed
utilizing NEC compliant junction boxes.
This product is suitable for damp locations.
This product may be dimmed with a low-voltage electronic
dimmer.
This instruction shows a typical installation.
BCATH OLLECTION
4
5
DRIVER
3
#8-32 SCREW