Installation Sheet

ManualsBrandsTech Lighting ManualsShop All Tech LightingTech Lighting Siber 36" x 25" LED Lighted Recessed Rectangular Mirror

1.0

Installation Instructions for

Siber Mirror Surface (LED)

700BCSIBS_-LED_

920BCSIBSD

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

This product may be dimmed with a low voltage electronic

dimmer.

Bring power supply lines to the mirror in accordance with

local electrical codes.

This instruction shows a typical installation.

BCATH OLLECTION

Install the Hardware

Locate the studs on the wall where the mirror is going

to be mounted (Max 28-1/4" separation).

Use minimum of four slots to mount the back plate to

the studs with the provided four screws and washers .

Do not drive the screws all the way in at this time.

Bring conduit to one of the four circular holes on the

backplate.

While holding the back plate level and in the desired

position, tighten the four screws to secure it.

SCREW

BACKPLATE

STUD

CONDUIT

WASHER

1 1

4 4

2 2

CAUTION RISK OF FIRE-

This product must be installed in accordance with the

applicable installation code by a person familiar with the

construction and operation of the product and the

hazards involved.

Use minimum 90°c supply conductors.

Summary of content (4 pages)

PAGE 1
920BCSIBSD Installation Instructions for Siber Mirror Surface (LED) 700BCSIBS_-LED_ B ATH C OLLECTION GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. This product may be dimmed with a low voltage electronic dimmer. Bring power supply lines to the mirror in accordance with local electrical codes. This instruction shows a typical installation.
PAGE 2
Prepare the Fixture for Installation Install the Fixture 2A 3A PAN HOLE THREADED ROD 2 3 KNOCKOUT 1 POWER LINE 2 CONDUIT CONNECTOR LID 1 Remove the six screws on the side of the center housing in the center of the pan. 1 Feed the conduit through the conduit connector into the pan. 2 Remove the center housing lid. 2 Place the four pan holes onto the four back plate threaded rods. 3 Remove one knockout and install the provided conduit connector.
PAGE 3
C 3D ANCHOR HOLE ANCHOR HOLE 9 8 7 ANCHOR HOLE ANCHOR HOLE 7 Connect the fixture to a suitable ground in accordance with local electrical codes. 8 Connect the neutral power line wire to the white fixture wire with a wire nut. 9 Connect the hot power line wire to the black fixture wire with a wire nut. ANCHOR SCREW 4 6 3E WASHER 4 Line up each anchor with the center of a backplate hole and push the anchor in up to the threads. 5 Screw the anchors the rest of the way in with a screwdriver.
PAGE 4
Install the Mirror 4A MIRROR HINGE 1 1 1 1 1 Carefully attach the mirror hinge onto the fixture and tighten all four screws. SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 847.410.4400 www.techlighting.com © 2016 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right to change specifications for product improvements without notification.