Installation Sheet

Remove the mounting plate and driver from the canopy.

Secure the mounting plate to ceiling. CAUTION: mounting screws must be screwed into a solid structure capable of supporting

the fixtures weight.

Determine the desired height of the fixture using the provided stems and half ball/upper stem and assemble them by screwing them

together.

Slide the canopy, then the collar nut onto the half ball/stem assembly.

Feed the fixture wires through the stem assembly, then screw the stem assembly to the top of the fixture base.

Seat the half ball into the mounting plate ensuring no wires are being pinched.

Connect the negative (-) fixture wire to the negative (-) output driver wire with a wire nut.

Connect the positive (+) fixture wire to the positive (+) output driver wire with a wire nut.

Connect the fixture to a suitable ground in accordance with local electrical codes.

Connect the white input driver wire to the neutral power line wire with a wire nut.

Connect the black input driver wire to the hot power line wire with a wire nut.

Neatly place the driver, wire, and wire nut connections inside the canopy/electrical box, then slide the canopy up over the mounting

plate and secure in place with the collar nut.

Install the shades onto the LED assemblies and place them securely in the shade ring.

The brass tip on op of the shade arms may be replaced with the black caps if desired.

Install the Fixture

DRIVER

MOUNTING

PLATE

HALF BALL/

UPPER STEM

CANOPY

COLLAR NUT

SHADE

SHADE RING

LED ASSEMBLY

BRASS TIP

BLACK CAP

MOUNTING

PLATE

MOUNTING SCREW

AND WASHER

SHADE ARM