Installation Sheet

1.1

Installation Instructions for

Dessau Wall

700DES12, 700DES18, 700DES24

920WSDESSAU

WALL

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

Use approximate 2x4 single gang junction box or

provided goof plate to completely cover the junction box.

This product is suitable for damp locations.

This product can be dimmed with most ELV or TRIAC dimmers.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

7400 Linder Ave, Skokie, 60077IL

847.410.4400

www.techlighting.com

Visual Comfort Group

PAGE 1
920WSDESSAU Installation Instructions for Dessau Wall 700DES12, 700DES18, 700DES24 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. WALL GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes.
PAGE 2
Install the Fixture 1A JUNCTION BOX 3 6 8 MOUNTING PLATE ALLEN WRENCH & SCREW 7 DRIVER 5 4 GOOF PLATE #6-32 SCREW 1 With the provided Allen wrench, remove the Allen screws on the fixture base. 2 Remove the mounting plate from the fixture base 3 Connect the black/blue driver wire to the black/blue fixture wire with a wire nut. 4 Connect the red driver wire to the red fixture wire with a wire nut. 5 Connect the fixture to a suitable ground in accordance with local electrical codes.