Installation Sheet

2
2
1
With the provided Allen wrench, remove the Allen screws on the fixture base.
Remove the mounting plate from the fixture base
Connect the black/blue driver wire to the black/blue fixture wire with a wire nut.
Connect the red driver wire to the red fixture wire with a wire nut.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white driver wire to the neutral power line with a wire nut.
Connect the black driver wire to the hot power line with a wire nut.
For 277V Only: Connect the purple and gray wires to a compatible dimmer. If not using 0-10V dimming, cap off the purple and gray
wires.
Properly place the driver, all wires, and wire nut connections into the junction box, and install the mounting plate to the junction box
with the two #6-32 screws provided. NOTE: Must use approximate 2x4 junction box or goof plate to completely cover the junction
box.
Mount the fixture base onto the mounting plate, and secure it in place by reinstalling the Allen screws using the provided Allen wrench.
1A
Install the Fixture
4
3
6
5
7
9
8
JUNCTION BOX
10
7
6
ALLEN WRENCH
& SCREW
5
MOUNTING
PLATE
#6-32
SCREW
DRIVER
4
3
8
GOOF PLATE