Installation Guide

1.6
Installation Instructions for
Lil Wonder & Lil Big Wonder
700F1_ , 700F2_
1
920LILWON
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
The anchors provided with this product are for drywall. Use
proper anchors for mounting onto other type of surfaces.
This product is suitable for dry locations only.
FLOOR FIXTURES
Installing the Switch
Choose a place on the cord where the switch is to be
mounted.
With a sharp knife cut about a 1" slot in the cord web.
Make sure not to nick the insulation on either wire.
Cut the smooth wire in half.
WIRE WEB
SMOOTH WIRE
1"
RIDGED WIRE
UPPER HALF OF THE SWITCH
SHARP
POINTED
PRONG
LOWER HALF OF
THE SWITCH
NUT
SMOOTH WIRE
RIDGED WIRE
SHARP
POINTED
PRONG
Loosen the screw on upper half of the switch to remove
the nut on the lower half.
Place the cord in the lower half of the switch (the half
without the wheel). The cut wire runs through the
center of the switch.
Press both halves back together. Replace the nut in the
lower half and tighten the screw on upper half so that
the sharp pointed prongs in upper half of the switch
pierce the wire insulation and make contact inside.
1
2
3
4
5
6
1A
2
3
1B
4
5
6