Installation Sheet

3
Install Optional Candle Accessories
8A
CANDLE
ACCESSORY
CAP
1
FIXTURE
2
Loosen (do not remove) the set screws on the canopy
strain relief on the side which needs adjusting.
Evenly and gently pull out the coaxial cable, in very small
increments, through the strain relief to adjust whichever
side to level the fixture.
Ensure that the fixture is level and re-tighten the set
screw on the strain relief.
STRAIN RELIEF
1
7A
2
2
Additional Leveling (optional)
NOTE: If necessary, minor leveling adjustments to
the fixture may be needed. It is recommended that
one person hold the fixture straight with the use of
a level while the other adjusts the coaxial cable.
CAUTION: Only pull out extra cable for leveling if
enough cord was left behind the canopy. Minimal
amounts of cord should be pulled out for fine
leveling.
3
1
CAUTION: Make sure to support the fixture if fine
leveling is necessary.
Place the candle accessory onto the fixture and screw
the cap on to secure in place.
Refer to the diagram on the next page for the designer’s
recommended installation of candle accessories for the
best aesthetic appearance.
Place all wires and wire nut connections properly inside
the canopy.
Align the canopy center hole with the crossbar center
hole.
Slide the canopy up against the ceiling and secure it in
place by tightening the decorative bolt.


























DECORATIVE
BOLT
CANOPY
































































































6A
2
3
1
Complete Installation
N
5
6
DRIVER DRIVER
















































































































































N
L
L
5B
Connect the black 120V input wires from each driver to
the hot power line wire with a wire nut.
Connect the white 120V input wires from each driver to
the neutral power line wire with a wire nut.
5
6