Installation Sheet

1.9
Installation Instructions for
2" Square Flush Canopy
700FJ2SQ67_
1
920FJ2SCN
GENERAL PRODUCT INFORMATION:
This product is suitable for indoor dry locations only.
Install the 2" electrical box prior to these steps.
Model numbers ending in “-LED” or “-LED277” can be
dimmed with a low-voltage electronic dimmer, have a rated
maximum output of 10 watts, and are compatible with LED
elements.
All other model numbers can be dimmed with a standard
incandescent dimmer, have a rated maximum output of 75
watts, and are not compatible with LED elements.
SINGLE PORT CANOPIES
1A
#6 SCREWS
#6 SCREWS
FRONT COVER
Remove two #6 opposing screws from the front cover
of the 2" Electrical box.
FRONT COVER
#4-40 SCREWS
DRESSING
PLATE
In accordance with local electrical codes, ground the
transformer green wire.
Connect the white transformer wire to the neutral
power line wire with a wire nut.
Connect the black transformer wire to the hot power
line wire with a wire nut.
Place the transformer and all the wires inside the 2"
electrical box. Use the adhesive pads to secure the
transformer in the electrical box.
Replace and tighten the two #6 screws on the front
canopy.
Mount the 2" square canopy to the 2" electrical box
with two #4 screws from the both sides.
1
3
1B
2
4
5
6
7
3
4
7 7
1
1
CAUTION—RISK OF FIRE
This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.