Installation Guide

ManualsBrandsTech Lighting ManualsLightingFreeJack Fire Translucent Steel Blue Murano Glass Pendant - 12v Halogen

2.1

Installation Instructions for

Fire, Inner Fire, & Firebird

700FJFIR_

920FJFIRE

PENDANTS-LOW VOLTAGE

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

This product is patented (U.S. PAT. 6,183,297).

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Cut the coaxial cable to the desired length.

Gently twist the end of the coaxial cable between thumb

and forefinger.

Tap the conical connector on a hard surface with the set

screw facing down, so the plate inside drops into place.

PLATE

SURFACE

Summary of content (4 pages)

PAGE 1
920FJFIRE Installation Instructions for Fire, Inner Fire, & Firebird 700FJFIR_ 2.1 PENDANTS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. This product is patented (U.S. PAT. 6,183,297). Adjust The Fixture Height 1A 1C ALLEN WRENCH SET SCREW 5 1 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
1H 1E 11 7 CONICAL CONNECTOR OUTER WRAPPED WIRE STOPS HERE 7 11 Firmly tighten the set screw on the conical connector. Feed and push the coaxial cable into the conical connector. The coaxial cable will come to a stop point after being inserted 3/4" into the conical connector. 1F 1I WRINKLE ON OUTER WRAPPED WIRE 8 12 INNER WIRE STOPS HERE 8 Keep pushing the coaxial cable into the connector while rotating the connector to ease feeding the inner wire into the tip of the connector.
PAGE 3
Replacing the Lamp C AUTION: To reduce the risk of a burn or electric shock during relamping, disconnect the power to the fixture. Use MAX 50 Watt Halogen Bi-Pin Lamp. 2A 2C SOCKET INNER GLASS SHADE 1 OUTER GLASS SHADE 1 4 Lift the glass shades up to expose the socket. NOTE: Use only your fingers and a soft cloth to 3 Handle the new replacement lamp with a soft cloth to prevent the natural oils on the fingertips from collecting on the lamp. This will help extend the life of the lamp.
PAGE 4
IMPORTANT SAFETY INSTRUCTIONS Halogen Lamp General Information To reduce the risk of fire, electrical shock, exposure to excessive UV radiation, or injury to person: – It is normal for a new halogen lamp to smoke slightly on first use. The protective coating is being vaporized. – Use this fixture indoors only. – Do not look directly at the lighted lamp. Prolonging Halogen Lamp Life – Do not remain in light if skin feels warm. – Do not touch the lamp with bare hands.