Installation Guide

Firmly tighten the set screw on the conical connector.
Pull the coaxial cable toward the fixture to smooth the
wrinkles.
2
Keep pushing the coaxial cable into the connector while
rotating the connector to ease feeding the inner wire
into the tip of the connector. The outer wrapped wire
will start wrinkling while being inserted another 1/2" into
the connector.
WRINKLE ON OUTER
WRAPPED WIRE
INNER WIRE STOPS HERE
Look into the sight hole on the top of the connector to
make sure that the inner wire is contacting the end of
the connector.
Hold the coaxial cable in place and tighten the set screw
on tip of the connector with the provided Allen wrench.
Make sure this set screw connection is tight.
SIGHT HOLE
INNER WIRE
ALLEN WRENCH
1F
8
9
10
8
9
10
1H
11
1I
12
12
1G
Feed and push the coaxial cable into the conical
connector. The coaxial cable will come to a stop point
after being inserted 3/4" into the conical connector.
CONICAL CONNECTOR
OUTER WRAPPED
WIRE STOPS HERE
1E
7
7
11