Installation Sheet

1.1

Installation Instructions for

P-LVENDANTS OW OLTAGE

GP I :ENERAL RODUCT NFORMATION

This product is listed and suitable only for indoor dryETL

locations and approved for use at any height above the

finished floor.

Adjust The Fixture Height

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Install the Glass

BASE

GLASS

Mara Pendant

700 _FJMRA

920FJMARA

Install the glass by screwing it into the base. Do not

over-tighten.

PAGE 1
920FJMARA Installation Instructions for Mara Pendant 700FJMRA_ 1.1 P ENDANTS -L OW V OLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Install the Glass Adjust The Fixture Height 1A 2A ALLEN WRENCH SET SCREW 1 1 Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
C 2G ALLEN WRENCH INNER WIRE 5 10 9 4 Cut the coaxial cable to the desired length. 5 Gently twist the end of the coaxial cable between thumb and forefinger. SIGHT HOLE 9 Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector. 10 Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.