Installation Sheet

1.0

Installation Instructions for

Tibor Pendant (LED)

700FJTBRC_-LED

920FJTIBOR

PENDANTS-LOW VOLTAGE

GENERAL PRODUCT INFORMATION:

This product is ETL listed and suitable only for indoor dry

locations and approved for use at any height above the

finished floor.

Assemble the Fixture

SET SCREW

Back out (do not remove) the set screw on tip of the

connector with the provided Allen wrench.

ALLEN WRENCH

SET SCREW

Back out (do not remove) the set screw on the conical

connector with the provided Allen wrench.

Pull the coaxial cable out.

ALLEN WRENCH

Adjust The Fixture Height

Screw the crystal pendant completely into the fixture

base.

CRYSTAL PENDANT

FIXTURE BASE

PAGE 1
920FJTIBOR Installation Instructions for Tibor Pendant (LED) 700FJTBRC_-LED 1.0 PENDANTS-LOW VOLTAGE GENERAL PRODUCT INFORMATION: This product is ETL listed and suitable only for indoor dry locations and approved for use at any height above the finished floor. Assemble the Fixture Adjust The Fixture Height 1A 2A ALLEN WRENCH FIXTURE BASE SET SCREW 1 1 1 CRYSTAL PENDANT Back out (do not remove) the set screw on tip of the connector with the provided Allen wrench.
PAGE 2
C 2G ALLEN WRENCH INNER WIRE 5 10 9 4 Cut the coaxial cable to the desired length. 5 Gently twist the end of the coaxial cable between thumb and forefinger. SIGHT HOLE 9 Look into the sight hole on the top of the connector to make sure that the inner wire is contacting the end of the connector. 10 Hold the coaxial cable in place and tighten the set screw on tip of the connector with the provided Allen wrench. Make sure this set screw connection is tight.