Installation Sheet

CEILING

Installing the Fixture

Mount the mounting plate to the electrical box using

the provided #8-32 screws.

1.0

Installation Instructions for

700FMAKV

920FMAKOVA

Akova Ceiling

#8-32 SCREW

MOUNTING

PLATE

ELECTRICAL

BOX

MOUNTING

PLATE

FIXTURE

SCREW

FIXTURE

BASE

Remove the fixture screws located on both sides of the

fixture base using the provided Allen wrench.

Remove the mounting plate from the fixture base.

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This instruction shows a typical installation.

ALLEN

WRENCH

NOTE: Install the mounting plate so that the studs

are parallel or perpendicular to the walls, this will

ensure that the fixture is oriented to the room.

PAGE 1
920FMAKOVA Installation Instructions for Akova Ceiling 700FMAKV 1.0 CEILING GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a low-voltage electronic dimmer. This instruction shows a typical installation.
PAGE 2
1C MOUNTING PLATE 4 6 DRIVER 5 SAVE THESE INSTRUCTIONS! 4 Connect the fixture to a suitable ground in accordance with local electrical codes. 5 Connect the fixture white wire to the neutral power line wire with a wire nut. 6 Connect the fixture black wire to the hot power line wire with a wire nut. 7 Properly place the driver, all wires, and wire nut connections into the electrical box.