Installation Sheet

Installation Instructions for

CEILING

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

GP I :ENERAL RODUCT NFORMATION

This product is suitable for damp locations.

These fixtures are intended to be installed

utilizing NEC compliant junction boxes.

This product can be dimmed with most ELV or TRIAC dimmers.

This instruction shows a typical installation.

SAVE THESE INSTRUCTIONS!

7400 Linder Ave, Skokie, 60077IL

847.410.4400

www.techlighting.com

a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right

to change specifications for product improvements without notification.

A Generation Brands Company

1.1

700FMOBL

920FMORBEL

Orbel Ceiling

PAGE 1
920FMORBEL Installation Instructions for Orbel Ceiling 700FMOBL 1.1 CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. CEILING Use minimum 90°c supply conductors. GENERAL PRODUCT INFORMATION: This product is suitable for damp locations. These fixtures are intended to be installed utilizing NEC compliant junction boxes.
PAGE 2
Install the Fixture 1A H N MOUNTING PLATE FIXTURE BASE 2 2 #8-32 SCREW FIXTURE SCREW 8 SHADE 1 2 Unscrew and remove the fixture screws around the fixture base, then remove the mounting plate. Secure the mounting plate to the electrical box with the #8-32 screws. 3 Connect the fixture to a suitable ground in accordance with local electrical codes. 4 Connect the white fixture wire to the neutral power line with a wire nut. 5 Connect the black fixture wire to the hot power line with a wire nut.