Installation Sheet

CEILING COLLECTION

Install the Fixture

SHADE

FIXTURE BASE

Insert a flat head screw driver into the slot on the shade

and separate the shade from the fixture base.

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This fixture may be ceiling or wall mounted.

This instruction shows a typical installation.

1.0

Installation Instructions for

Rhonan Flush Mount ( )LED

-700FMRHNS_ LED

920FMRHON

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Remove the mounting plate from the fixture base by

unscrewing the two knurled nuts.

MOUNTING

PLATE

KNURLED NUT

SLOT

PAGE 1
920FMRHON Installation Instructions for Rhonan Flush Mount (LED) 700FMRHNS_-LED 1.0 CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
PAGE 2
Install the Shade 2A 1C FIXTURE BASE 3 3 MOUNTING PLATE #8-32 SCREW MAGNET Secure the mounting plate to the electrical box with 2 #8-32 screws. 3 NOTE: Install the mounting plate so that the studs are parallel or perpendicular to the walls, this will ensure that the fixture is oriented to the room. SHADE 2 1D 4 MOUNTING PLATE 5 6 1 SAFETY BRACKETS 4 Connect the fixture to a suitable ground in accordance with local electrical codes.