Installation Sheet

ManualsBrandsTech Lighting ManualsIndoor Ceiling FixturesVance Convertible 18" Wide Integrated LED Flush Mount Ceiling Fixture / Wall Sconce with a Frosted Glass Shade

1.0

Installation Instructions for

Vance and Lance 18 and 24 Flush Mount

700FMVNC, 700FMLNC

920FMVANLAN

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

CEILING COLLECTION

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed

utilizing compliant junction boxes.NEC

This product is suitable for damp locations.

This product can be dimmed with a low-voltage electronic

dimmer.

This instruction shows a typical installation.

Prepare the fixture

(2.75” J-Box Screw Spacing)

Align the Key Slots in the fixture base with the #8-32

screws installed in the junction box.

Push the Key Slots on to the #8-32 screws and twist the

fixture base counter-clockwise to temporarily lock it into

position.

Lightly tighten the #8-32 screw to hold the fixutre base

in place through the next steps.

Partially screw 2 #8-32 screws. Into the Junction box.

#8-32 SCREW

For all other J-Boxes: skip ahead to section 2A.

KEY SLOT

FIXTURE

BASE

#8-32

SCREW

Summary of content (4 pages)

PAGE 1
920FMVANLAN Installation Instructions for Vance and Lance 18 and 24 Flush Mount 700FMVNC, 700FMLNC 1.0 CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. This product can be dimmed with a low-voltage electronic dimmer.
PAGE 2
Prepare the fixture (3.5” J-Box Screw Spacing) 1C 2A 1B ANCHOR SCREW HOLE FIXTURE BASE FIXTURE BASE 1 1 2 5 5 5 5 2 2 3 #8-32 SCREW 5 With a pencil, mark the location of the 4 anchor screw holes in the fixture base. 6 Remove the fixture base from the ceiling. (Reverse of 1B.) 2 1 Align the through holes in the fixture base with the #832 screws to junction box. 3 2 Lightly tighten the #8-32 screws to hold the fixture base in place through the next steps.
PAGE 3
Install the Fixture (2.75” J-Box Screw Spacing) 1D 4A 5 1 CEILING 5 #8-32 SCREW Using the mark points that were determined in step 5, tap the anchor into the ceiling up to the threaded portion with a hammer. 1E FIXTURE BASE 1 KEY SLOT CEILING ANCHOR 2 6 6 Screw the anchor in the rest of the way with a Phillips screwdriver. Connect the Fixture (All J-boxes) 3A 1 2 2 1 Align the Key Slots in the fixture base with the #8-32 screws installed in the junction box.
PAGE 4
Complete the install (All J-boxes) 7B THUMB SCREW FIXTURE BASE 6A 1 SHADE 1 1 1 #8 SCREW 1 Place the four provided #8 screws in the holes and carefully tighten them to be sure to not damage the LED board. 3 Locate the small threaded hole on the top side of the shade. 4 Screw the thumb screw into the shade to secure it in place. Install the Shade Install the Trim Accessories(Lance only) 7A FIXTURE BASE NOTE: The Lance ships with several trim accessories depending on the size of the fixture.