Installation Sheet

Installation Instructions for

Vetra Ceiling

920FMVETRA

Install the Mounting Plate

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is suitable for damp locations.

Incandescent version may be dimmed with a standard incandescent

dimmer. LED version may be dimmed with a LED dimmer. Consult

lamp manufacturer for additional information.

This instruction shows a typical installation.

Remove the mounting plate from the fixture by

unscrewing the two knurled nuts from the two

threaded studs.

KNURLED NUT

THREADED

STUD

MOUNTING

PLATE

FIXTURE BASE

Install the Mounting Plate

Remove the three mounting rods by hand and separate

the shade from the fixture.

FIXTURE BASE

MOUNTING ROD

SHADE

MOUNTING

PLATE

#8-32 SCREW

ELECTRICAL BOX

Mount the mounting plate to the electrical box with

the two #8-32 screws.

1.0

700FMVTR

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

CEILING COLLECTION

PAGE 1
Installation Instructions for 920FMVETRA Vetra Ceiling 700FMVTR 1.0 CEILING COLLECTION GENERAL PRODUCT INFORMATION: These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations. Incandescent version may be dimmed with a standard incandescent dimmer. LED version may be dimmed with a LED dimmer. Consult lamp manufacturer for additional information.
PAGE 2
Install the Fixture 2C 2A 1 3 2 LAMP 6 SOCKET C AUTION: To reduce the risk of a burn or electric shock during re-lamping, disconnect the power to the fixture. FIXTURE BASE Refer to fixture marking for lamp information. 1 Connect the mounting plate ground wire to a suitable ground in accordance with local electrical codes. 6 2 Connect the white fixture wire to the neutral power line wire with a wire nut. 2D 3 Screw the lamps into the sockets.