Installation Sheet

2
Connect the mounting plate ground wire to a suitable
ground in accordance with local electrical codes.
Connect the white fixture wire to the neutral power line
wire with a wire nut.
Connect the black fixture wire to the hot power line
wire with a wire nut.
2A
1
2
3
1
2
3
Install the Fixture
FIXTURE BASE
2B
24
Properly place all wires and wire nut connections into
the fixture.
Mount the fixture onto the threaded studs on the
mounting plate and secure it by tightening the two
cap nuts.
CAP NUT
MOUNTING PLATE
25
FIXTURE BASE
2
Align the shade with the fixture base and re-install the
three mounting rods by hand.
7
5
5
2C
LAMP
6
6
Screw the lamps into the sockets.
CAUTION: To reduce the risk of a burn or electric
shock during re-lamping, disconnect the power to
the fixture.
Refer to fixture marking for lamp information.
SOCKET
2D
STUD
MOUNTING ROD
SHADE
7400 Linder Ave, Skokie, IL 60077
847.410.4400
www.techlighting.com
© 2018 Tech Lighting, L.L.C. All rights reserved. The "Tech Lighting" graphic is
a registered trademark of Tech Lighting, L.L.C. Tech Lighting reserves the right
to change specifications for product improvements without notification.
A Generation Brands Company
SAVE THESE INSTRUCTIONS!